Well, I finally acted on an interest that's been perculating in my brain for a bit. I bought a scrotum weight / stretcher. It's not that prepubescent balls have been a problem of mine; in fact, I've gotten more than a few nice comments in my personal photo section regarding my low hangers. It's also an issue between my boyfriend & myself. He doesn't like low hangers. He works as a mortician and says he and his friends have a good laugh at the dead guys who come in with a nut sack so low hanging that if they were so inclined (and amongst the living) could stuff their scrotum up their own anus. He, therefore, is somewhat proud of having a tight package. I disagree, obviously.

The first thing I tried was a leather scrotum wrap, weighted as it is filled with BBs. Nice in most respects but as typical with me I bit off more than I could chew getting one that was too broad. This resulted in a rather comical struggle trying to get the snaps together when the lower set were against my testicles. Ha ha. Not too terribly comfortable, either. That one ended up going into my rapidly filling up cigar box that I use for my genital accessories. I then focused on getting something much more narrow but also much denser and therefore heavier, good ol' stainless steel.

I found a rather gorgeous stainless steel collar that splits into two pieces and then goes together using an Allen wrench. I found this at Painful Pleasures but I know similar products can found at The Chain Gang, Amazon (through Painful Pleasures), and I believe Tribalectic. I chose one that was 370 grams (approximately 12 oz for us non-metric types) with a very nice oil slick finish to the steel. The inner diameter is 35 mm (1 & 2/5 ") that is adequate to accommodate the scrotal skin and assorted ball cableage. The outer diameter is something like 65 mm. It also came with two opposing eyelet screws that are easily detachable if you were so inclined to hang, I dunno, something like a potted plant from your junk for added weight. I removed these. I took a bit of a nap lying with the collar under my arm & when i awoke the steel had warmed up. I persuaded the boys to drop down with a bit manual warmth. Then, with just a little bit of pinching I was able to bring the two halts together & tighten the screws. It was now on, comfortable, and swinging fine!

I've worn it continuously for about a week now and it is impressive how low my balls now hang. They are a real pair of chin slappers now, lol. I've been impressed how tight the screws have held, I figured they'd work loose after awhile but when I checked they couldn't be tightened any more than they were already. It hangs just above the testicles with absolutely no way it'll slip off. I shower with it, soap up the area real good. It'll slip a little up so I can clean beneath but otherwise is solid. I'm not worried about it being too tight as the skin color below is normal, there's no pain, & the is no ulceration of the skin. In general, it feels like someone is firmly but not painfully gripping my balls all day long =P.

Has the experience all been positive? No, not really. When out & about good support is a must as otherwise there's a lot of pinching of my scrotum between my legs and whatever I'm sitting upon. This was bad enough that at work today I took a brief break to run to a local clothing store as I had worn boxers that am and the pinching was something fierce. I bought a pack of briefs. Boxer briefs or brief are good with briefs that have a pouch that lifts and shift the package forwards the best. That option also has the dubious benefit of giving me a bulge that'll could passing folks to stumble in the hall considering nature's gifts, the 'wonder-briefs,' and that huge hunk of steel. There's also a new problem peeing if one is sitting down. My PA already causes an alteration of my stream, my penis normally drapes over my scrotum, but now with a the weight pulling the boys down they get in the way. Peeing on my own nads isn't my definition of a good time and has required new positioning experimentation. There's also the boyfriend who care for a swingin' sack but he doesn't like my mods in general so I've pretty much given up on getting his approval there. He only balks at the PA and by now I can take it out and put it back in with ease. On the balance, this weight ranks only second to my PA for fun body jewelry.

That about concludes my report on my most recent body mod experimentation. I'll likely update this page if I size up. The place I get them from has up to 800 g weight . I'll post a pict in my profile sometime tonight or tomorrow.